Altera DE0 FPGA

REF: A1336
Rated 0.3 out of 5

1 in stock

1,300.00DH

Description

  • FPGA:
    • Cyclone III 3C16 FPGA
      • 15,408 LEs.
      • 56 M9K Embedded Memory Blocks.
      • 504K total RAM bits.
      • 56 embedded multipliers.
      • 4 PLLs.
      • 346 user I/O pins.
      • FineLine BGA 484-pin package.
  • Memory:
    • SDRAM
      • One 8-Mbyte Single Data Rate Synchronous Dynamic RAM memory chip.
    • Flash memory
      • 4-Mbyte NOR Flash memory.
      • Support Byte (8-bits)/Word (16-bits) mode.
    • SD card socket
      • Provides both SPI and SD 1-bit mode SD Card access.
  • Interface:
    • Built-in USB Blaster circuit
      • On-board USB Blaster for programming.
      • Using the Altera EPM240 CPLD.
    • Altera Serial Configuration device
      • Altera EPCS4 serial EEPROM chip.
    • Pushbutton switches
      • 3 pushbutton switches.
    • Slide switches
      • 10 Slide switches.
    • General User Interfaces
      • 10 Green color LEDs.
      • 4 seven-segment displays.
      • 16×2 LCD Interface (Not include LCD module).
    • Clock inputs
      • 50-MHz oscillator.
    • VGA output
      • Uses a 4-bit resistor-network DAC.
      • With 15-pin high-density D-sub connector.
      • Supports up to 1280×1024 at 60-Hz refresh rate.
    • Serial ports
      • One RS-232 port (Without DB-9 serial connector).
      • One PS/2 port (Can be used through a PS/2 Y Cable to allow you to connect a keyboard and mouse to one port).
    • Two 40-pin expansion headers
      • 72 Cyclone III 3.3V I/O pins, as well as 8 power and ground lines, are brought out to two 40-pin expansion connectors.
      • 40-pin header is designed to accept a standard 40-pin ribbon cable used for IDE hard drives.

 

Reviews

There are no reviews yet.

Be the first to review “Altera DE0 FPGA”